Jump to content



Photo

Seitz Follow Focus Pinout


  • Please log in to reply
2 replies to this topic

#1 charlesneufeld

charlesneufeld

    Advanced Member

  • Sustaining Members
  • 170 posts

Posted 22 July 2004 - 01:56 PM

Hey Guys,

Do any of you have the pinout for the DB9 connector on the 8720A receiver??
Also, perhaps the 4 pin lemo connectors on the Servo amp(8725A) aswell?

I have looked in the manual but no luck... <_<
Thanks Alot!

Charles :)
  • 0

#2 Brad Hruboska

Brad Hruboska

    Advanced Member

  • Sustaining Members
  • 157 posts
  • Toronto

Posted 23 July 2004 - 10:46 AM

Charles...... call seitz or.......
following my oldest diagrams here... model 2 era......
pin 1 All lemos is red... +12 v which feeds to D connector pin 7 use double gauge to connect to handle the amperage draw if you are making a cable of any length.
Channel 1 lemo
pin 2 feeds to pin 5 on D connector
pin 3 feeds to pin 3 for ground .
pin 4 NC

Channel 2 lemo
pin 2 feeds to pin 8 on D connector
pin 3 feeds to pin 3 for ground
pin 4 NC

Channel 3 lemo
pin 2 feeds to 9 on D connector
pin 3 feeds to pin 3 for ground.

contacts used for motor control on the "D" connector are, 3, 4, 5, 7, 8, 9
hope this helps.



:blink:
  • 0

#3 charlesneufeld

charlesneufeld

    Advanced Member

  • Sustaining Members
  • 170 posts

Posted 23 July 2004 - 06:33 PM

Hey Brado,

Thanks so much :) , I will call seitz to make sure it is all good. I suppose I could also open up the units and derive the pinouts from there aswell.... :ph34r:

Thanks again!
Charles
  • 0




Paralinx LLC

SkyDreams

Ritter Battery

Betz Tools for Stabilizers

Boland Communications

BOXX

Media Blackout - Custom Cables and AKS

GPI Pro Systems

Omnishot Systems

PLC Electronics Solutions

IDX

Wireless Video Systems

Varizoom Follow Focus

rebotnix Technologies

Engineered Cinema Solutions

PLC - Bartech

Teradek