Wiring for TALLY IN/ OUT Shadow V50
Posted 29 September 2016 - 01:29 PM
Does anyone have a picture or details for the wiring of the tally in/ out connector on the Shadow V50 rig?
Sent from my iPhone using Tapatalk
Posted 30 September 2016 - 04:41 AM
Your Shadow V should have the same 4 pin Lemo as the M-1, wiring can be found in the on-line manual
Please note that this is an active circuit designed to power the Tiffen tally sensor so is a little more complicated than just a through connection, if you are in the US a call to the factory would be a good idea. Also I suggest you change your identity to your full name, this forum is pretty hot on that :-)
Posted 30 September 2016 - 05:15 AM
Thanks for your reply. I found the tally cable you mentioned and managed to get it to work, however it isn't sending tally to the monitor via the accessory cable.
I've been through the monitors settings but still can't get it to work.
Sent from my iPad using Tapatalk