Hope you are all well and busy!
I own an ultra rig.
I just replaced my gimbal pan bearing with a new one.
My rig spins fine when its vertical, but when it goes horizontal,( tilt the lens up)...........gimbal locks itself.
I know, gimbal centring is needed, adjusting the the two side screws, turning them both on each side, 1/4 of a turn each time, etc.
BUT WHAT IF both screws ar totally unbalanced by a reason????
What if the one is totally unscrew and the other to an ''X'' (whatever) position?????
I am afraid, if I will not be able to start from a "default'' screw position, centric gimbal is only a mater of luck....