Jump to content


6 pin Hirose HR10-7R-6s wire color code

  • Please log in to reply
3 replies to this topic

#1 Nelson Reis

Nelson Reis


  • Members
  • PipPip
  • 20 posts

Posted 24 June 2013 - 02:33 PM

Hey Guys,

Just wondering if any anybody knows the color code diagram wiring for the hr10-7r-6s hirose cable ?
  • 0

#2 Chris Van Campen

Chris Van Campen

    Advanced Member

  • Sustaining Members
  • 129 posts

Posted 24 June 2013 - 03:54 PM

Hey Nelson, if you're talking about the 6-pin Hirose on the the bottom/front of the Zephyr, there's a breakout diagram by pin # in the Zephyr manual. The PDF is over on the Tiffen site.


good luck...

  • 0

#3 Nelson Reis

Nelson Reis


  • Members
  • PipPip
  • 20 posts

Posted 24 June 2013 - 06:14 PM

Yes thast the hirose im trying to figure it out ..in the manual they tell you the pin number and its correspendent however the info im after its what cable corresponds to what pin ..they are 6 cables
Yellow , black,brown, 2x whites , 2x reds ..just trying to make my own breakout cable
  • 0

#4 Afton Grant

Afton Grant

    Advanced Member

  • Moderators
  • PipPipPip
  • 906 posts
  • New York, Boston

Posted 24 June 2013 - 07:31 PM

Hey Nelson,


It doesn't matter.  The colors are nothing but jacketing over copper wire - and each wire is the same copper (usually).  You can attach any color you want to any pin on the hirose you want.  What matters is then how you correspond the wires with the connector pins at the other end of the cable.  One general rule, however, is ground is usually black and the + voltage is usually red.  By no means is this a requirement though.  

  • 0

Camera Motion Research

rebotnix Technologies

Varizoom Follow Focus

Omnishot Systems

GPI Pro Systems

Paralinx LLC

Boland Communications

Ritter Battery



PLC Electronics Solutions

Wireless Video Systems


PLC - Bartech

Betz Tools for Stabilizers