Jump to content



Photo

VanMount


  • Please log in to reply
2 replies to this topic

#1 TJ Williams

TJ Williams

    Advanced Member

  • Members
  • PipPipPip
  • 213 posts
  • Seattle

Posted 26 March 2005 - 03:29 PM

Here are the pictures of the van mount I made. It is made of the same square steel tubing used to make trailer hitches and is very strong. No problem to throw a strap around this and pull a truck! This picture shows the angle from horizontal coming out of the hitch receiver to vertical with the foot pegs and the reinforcement flange.

Attached Files


  • 0

#2 TJ Williams

TJ Williams

    Advanced Member

  • Members
  • PipPipPip
  • 213 posts
  • Seattle

Posted 26 March 2005 - 03:34 PM

Here is the middle of the vertical post with the 2" center holes which allow mounting the plate which holds the steadicam mount. The plate is wrapped in an old towel to make it more operator friendly as there are some sharp corners.

Attached Files


  • 0

#3 TJ Williams

TJ Williams

    Advanced Member

  • Members
  • PipPipPip
  • 213 posts
  • Seattle

Posted 26 March 2005 - 03:37 PM

Here is the top of the post which shows the tennis ball mounted to the inner post which adjusts to keep the van rear lid up. The welded on nut and its bolt are similiar to the one added to the side of the hitch receptical to keep the mount from moving. also resting up against the top of the van on top tends to keep it from movement.

Attached Files


  • 0




Wireless Video Systems

PLC Electronics Solutions

Ritter Battery

rebotnix Technologies

Betz Tools for Stabilizers

Engineered Cinema Solutions

Omnishot Systems

The Moses Pole - Steadicam Monopod

PLC - Bartech

GPI Pro Systems

BOXX

Varizoom Follow Focus

Boland Communications

Paralinx LLC

Media Blackout - Custom Cables and AKS