Jump to content



Photo

XCS Ultimate Gimbal Sleeve for 1.58 posts (Tiffen)


  • Please log in to reply
No replies to this topic

#1 Grayson Austin

Grayson Austin

    Advanced Member

  • Sustaining Members
  • 89 posts

Posted 24 April 2012 - 09:49 PM

Unused as New XCS Ultimate Sleeve for Tiffen centerposts (Ultra2, Ultra, Master, etc).
If you ever dreamed of putting an XCS gimbal on your Master Series or other 1.58 size center post, you need this sleeve. Then just buy the main gimbal bearing assembly from XCS and you are good. I was going to use it as a back up on my Ultra2 but did not need to and now the main gimbal bearing is on a 2 inch center post for another rig of mine so I no longer need this. If you buy it from XCS, it will cost you $1200 (maybe more now). Buy it from me same as new for $1000. Email me only at the email below. Thanks.

Grayson Grant Austin, SOC
graysonaustin@me.com

Attached File  XCSsleevephoto1.jpg   55.67KB   80 downloads
Attached File  XCSsleevephoto2.jpg   39.89KB   75 downloads
Attached File  XCSsleevephoto3.jpg   43.51KB   62 downloads
  • 0




Omnishot Systems

PLC Electronics Solutions

GPI Pro Systems

Boland Communications

Media Blackout - Custom Cables and AKS

Ritter Battery

The Moses Pole - Steadicam Monopod

BOXX

Wireless Video Systems

rebotnix Technologies

Engineered Cinema Solutions

Paralinx LLC

Betz Tools for Stabilizers

PLC - Bartech

Varizoom Follow Focus