Jump to content


FOR SALE - Steadyrig Centre Post & Upper Junction Box

  • Please log in to reply
1 reply to this topic

#1 Hugo_Langer


    Advanced Member

  • Sustaining Members
  • 122 posts
  • Melbourne, VIC

Posted 05 March 2010 - 01:16 AM

Manufactured by Rig Engineering/Steadyrig

Anodised aluminium 1½" telescoping Centre Post with matching Upper Junction Box.

The post has laser engraved 1" and 1/10th" increments on both sections. Supplied with two tools-free lever clamp rings to permit adjustment but with a guaranteed lock-off.

This post has no slot cut down the lower/inner tube section which, as you would all know, provides much greater rigidity to the sled. The telescoping extension has an 11¾" range.

The lower end of the post has a bayonet socket, lever and clamp for fast attachment. The bayonet design is compatible with a Steadyrig Lower Junction Box, simple modification will be required to fit to other rigs.

The top of the post also has a bayonet arrangement which provides a fast, rigid and positive lock-off.

The Upper J Box has been manufactured to receive industry standard Lemo and BNC Sockets (PRO compatible). The base of the Upper J Box is machined so that a Lemo socket can be installed, allowing the Lemo plug at the top of the loom/cable harness to connect.

We were manufacturing Centre Posts with hard-mounted Upper J Boxes. We decided to manufacture more modular sleds with a bayonet arrangement. Going through the design and first machining processes resulted in prototype and set up errors and also minor design changes.

This Post and J Box is a fully operational unit. If you don't mind a few small cosmetic issues, then this equipment may well suit your needs.

After completing the machining of the Junction Box, we felt confident that we had all issues resolved. We then went ahead with the anodising and engraving. When we did a final, full assembly we came to realise that there was insufficient room within the Junction Box to turn the nuts on the back of some Lemos. To solve this problem we had some additional machining done, inside the box, after the anodising.

The top of the Upper J Box, on the outside, unfortunately was anodised with a matt finish and there are also slight blemishes on the anodising of the two blue levers.

Because this item has some manufacturing defects the asking price is US$1950.00. The catalog price for this item is US$2250.00.

We are including, at no cost, a new wiring harness/Loom that is capable of HD-SDI video.

** This junction Box does not come with sockets and is not wired. Wiring can be done by the purchaser or can be organised on the purchaser's behalf.

Please contact me with any questions or comments.

Kind regards,

Hugo Langer
Rig Engineering
Melbourne, Australia

tel: +61-3-9898-6298
fax: +61-3-9898-6218


Attached File  mIMG_0614.jpg   44.77KB   135 downloads
Attached File  mIMG_0612.jpg   34.29KB   164 downloads
Attached File  mIMG_0715.jpg   61.48KB   148 downloads
  • 0

#2 Hugo_Langer


    Advanced Member

  • Sustaining Members
  • 122 posts
  • Melbourne, VIC

Posted 10 March 2010 - 05:43 PM


  • 0

Varizoom Follow Focus


Omnishot Systems

GPI Pro Systems

Paralinx LLC

PLC Electronics Solutions

PLC - Bartech

Wireless Video Systems

Media Blackout - Custom Cables and AKS

Betz Tools for Stabilizers

The Moses Pole - Steadicam Monopod

Ritter Battery

Boland Communications

rebotnix Technologies

Engineered Cinema Solutions